Pulling The Ladder Out To Its Total Length; Collapsing The Ladder - Powerfix Profi 297345 Montage-, Bedienungs- Und Sicherheitshinweise

rungs which have not been pulled
out must be located at the top of
the ladder.
1. Place the ladder on a firm and
level surface.
2. Stabilise the ladder by putting
a foot on the base
3. Pull out the ladder rung by rung
from the bottom upwards until
you have achieved the desired
length (see Fig. D).
By means of the locking device,
each section is automatically
locked as soon as the respec-
tive rung
5
out to its maximum length.
4. Ensure that every ladder seg-
ment is locked before you get
on the ladder (see the chapter
"Locking device").
Pulling the ladder out
to its total length
1. Place the ladder on a firm and
level surface.
2. Stabilise the ladder by putting
a foot on the base
3. Pull out both of the top side rail
elements with the spacer
sure that the side rail elements
are locked.
52 GB/MT
.
2
has been pulled
.
2
. En-
10
4. Pull out the ladder rung by rung
from the bottom upwards until
you have achieved the total
length (see Fig. E and F).
Ensure while doing so that the
locking devices of the ladder
are only locked when you have
pulled out the ladder to its total
length.
5. Ensure that every ladder seg-
ment is locked before you get
onto the ladder (see the chapter
"Locking device").

Collapsing the ladder

If you press the bottom re-
lease buttons (on the second
rung from below) every rung of the
above ladder part will be automati-
cally unlocked and collapsed. If you
begin with one of the upper rungs,
you will only unlock the rungs above
that and the rungs below that must
be unlocked separately.
1. Ensure that the ladder is placed
on a firm and level surface.
2. Ensure that your fingers, hands
and arms are at the same height
as the release buttons when col-
lapsing the ladder.
3. Press both of the release buttons
of a rung to the centre so that