Link State - Uponor C-46 Kurzanleitung

10 Linking radio thermostats
The Add links function is used to establish radio links between radio
sensors and Uponor Climate Controller C-46.
To add links to Uponor Climate Controller C-46:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings > Radio links > Add
links
2. Select the required sensor and press OK.
The next screen displays:
Add link
Wait link
14
The diagram above shows a number of heat curves for T-slope
parameter set between 0.1 and 1.4 and the T-adjustment parameter
set to 0.
The heat curves are also limited by the parameters Min., max. supply
temp. The default values for these parameters are 5 °C for the
minimum supply temperature and 40 °C for the maximum supply
temperature. In the diagram above, the parameter values 5 °C
respectively 70 °C have been used to show the full potential of the
system. See 8.5.4 for setting the parameters Min., max.
supply temp.
3. Initiate the linking process from the sensor.
The screen now displays:
Add link
Link in progress ...
4. When the linking process is finished, the following is displayed:

Link state

Link success
OK
In case the linking process fails, the following is displayed:
Link failure
In any case, press OK to return to the Add links menu.
U P O N O R C L I M AT E C O N T R O L L E R C - 4 6 - Q U I C K G U I D E