Installation Wizard; Quick Menu - Uponor C-46 Kurzanleitung

5 Installation wizard

When Uponor Climate Controller C-46 is started the very first time, it
will guide the operator to make the necessary primary settings of the
system.
The installation wizard is also started after changing or resetting the
operating mode.
5.1 Restarting the installation wizard
If there is any kind of mistake made when using the installation wizard,
then do this to restart it:
1. Press the the two keys and
Access level is displayed.
2. Confirm the selection by pressing OK.
3. Navigate through the screens using the navigation keys
Uponor > Main menu > Control settings > Advanced >
Operating mode
4. Select the preferred operating mode using the
5. Confirm the selection by pressing OK.
6. To answer the question Change Operating mode, are you sure?,
select Yes and press OK.
The installation wizard is now restarted and the next screen displays
sensors to be selected.

6 Quick menu

The Quick menu consists of a series of screens easily accessible from
the Uponor screen. These screens displays readings for daily use. If
Uponor Climate Controller C-46 is set to Installer access level, it is also
possible to modify some parameters.
U P O N O R C L I M AT E C O N T R O L L E R C - 4 6 - Q U I C K G U I D E
simultaneously until the screen
and keys.
For a full access to all screens in Uponor Climate Controller C-46, see
8.
6.1 Information screens
The information screens can be accessed when Uponor Climate
Controller C-46 is set up in Basic access level as well as Installer
access level.
To navigate through the information screens:
1. Press the key to display the next information screen.
Press the key to display the previous information screen.
6.2 Parameter screens
The parameter setting screens can only be accessed when Uponor
Climate Controller C-46 is set up in Installer access level.
To navigate through the parameter setting screens:
1. Press OK for two seconds to highlight the parameter.
2. Press the and keys to change the parameter value.
3. Press OK to confirm the setting.
4. Press the key to display the next screen.
Press the key to display the previous information screen.
7 Main menu
Starting operation
1. Press the OK button to display the Main menu screen.
The operation of Uponor Climate Controller C-46 is described in the
Operation Manual, that is found on the CD supplied with the
equipment.
11