Safety Instructions; Electrical Connection - Electrolux FQ945XE Benutzerinformation

4 www.electrolux.com
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal
•
scrapers to clean the glass door since they can scratch
the surface, which may result in shattering of the glass.
If the supply cord is damaged, it must be replaced by
•
the manufacturer, its Authorised Service Centre or
similarly quali ed persons in order to avoid a hazard.
To remove the shelf supports rst pull the front of the
•
shelf support and then the rear end away from the side
walls. Install the shelf supports in the opposite
sequence.
Only use the Food Probe recommended for this
•
appliance.

2. SAFETY INSTRUCTIONS

2.1 Installation
WARNING
Only a quali ed person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Obey the installation instruction
supplied with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Do not pull the appliance by the
handle.
• Keep the minimum distance from the
other appliances and units.
• Make sure that the appliance is
installed below and adjacent safe
structures.
• The sides of the appliance must stay
adjacent to appliances or to units with
the same height.

2.2 Electrical connection

WARNING
Risk of fire and electrical
shock.
• All electrical connections should be
made by a quali ed electrician.
• The appliance must be earthed.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not contact an
electrician.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug and to the mains cable.
Should the mains cable need to be
replaced, this must be carried out by
our Authorised Service Centre.
• Do not let mains cables to come in
touch with the appliance door, specially
when the door is hot.
• The shock protection of live and
insulated parts must be fastened in
such a way that it cannot be removed
without tools.