Safety Instructions
Safety during use
➜ Wear the appropriate protective clothing when working on the device (protective
glasses and, if necessary, safety gloves).
➜ Do not use the device in potentially explosive areas. The device is not protected
against explosion. There is no explosion or ATEX protection available.
➜ Do not carry out work with naked flames in the vicinity of the device (risk of
explosion).
➜ Do not operate any devices in the vicinity which may exhibit electromagnetic fields in
the frequency range 9 x 10
➜ Do not operate or assemble devices in the vicinity which are emission or radiation
sources (electromagnetic radiation) for the frequency range 3*10
(in the optical spectral range wavelengths from 1,000μ to 0.1μ).
➜ Do not operate or assemble appliances in the vicinity of the device which constitute
emission or radiation sources for ionizing radiation or in the ultrasonic range.
➜ Do not operate the device where adiabatic compression or shock waves might occur
(shock wave combustion).
➜ Do not use substances, where the energy input due to mixing might pose a hazard.
➜ Avoid putting pressure on the display when you are not operating the device.
➜ Do not spill liquids over the device or any parts of it.
➜ Remove any accidentally spilled liquids immediately.
➜ Eliminate errors immediately.
➜ Do not use abrasive material to clean the surface. Only wipe with damp cloth.
➜ Always switch the device OFF after use.
Disposal
3
Hz to 3 x 10
➜ Check the device components for hazardous substances and
solvents.
➜ Clean all components before disposal.
➜ Dispose of the device in accordance with the relevant national
regulations.
➜ Dispose of the packaging material in accordance with the
appropriate national regulations.
11
Hz.
9
11
15
Hz to 3*10
Hz