Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 609 929 894 - Buch Seite 1 Mittwoch, 1. Oktober 2003 9:10 09
Tool Specifications
Electric tacker
Order number
Impact rate
Intermittent operation,
max.
Staple width
Staple length (6 mm)
Staple length
(6 mm resin-covered)
Staple length (11.4 mm) [mm]
Nail/pin length
Magazine capacity,
max.
Weight without cable,
approx.
Protection class
Please observe the order number of your machine. The
trade names of the individual machines may vary.
Machine Elements
The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
1 Trigger lock
2 Trigger
3 Storage indicator
4 Face-plate screws
5 Face plate
6 Tacker head
7 Safety cover
8 Magazine slider
9 Thumbwheel for force selection
10 Load opening
11 Magazine
Not all of the accessories illustrated or described are
included as standard delivery.
Intended Use
The machine is intended for the tacking of card-
board, Insulating material, fabric, foils, leather
and similar materials on surfaces of wood or ma-
terials similar to wood. It is also suitable for the at-
tachment of wall and ceiling panelling.
8 • 1 609 929 894 • TMS • 26.09.03
PTK 19 E
0 603 265 0..
[bpm] 30
[min]
15
[mm]
6/11.4
[mm]
12 – 19
[mm]
19
8 – 18
[mm]
16 – 19
100
[kg]
1.5
/ II
English - 1
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
Always direct the cable to the rear away from
the machine.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Keep fingers away from the tacker head 6.
Never point the machine at persons or ani-
mals. Staples or nails shot from a short dis-
tance can cause considerable injuries.
Do not use the machine to fasten electrical wir-
ing.
For the fastening of ceiling coverings with
wooden profiles or joint claws, only hardened
staples with 19 mm length must be used.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
