Cleaning And Maintenance - Concept GE4020 Bedienungsanleitung

EN
OPERATING INSTRUCTIONS
1. Remove the thermostat unit with the heating element (2) from the base. The grill can only be used with the
collection tray (3). Fill the collection tray (3) with cold water up to the "MAX" mark on the level gauge. The water
level will decrease during grilling. Add water regularly to ensure that the collection tray is never completely empty.
Make sure the water never comes into contact with the heating element (2).
2. Connect the heating element (3) according to the assembly instructions.
3. Put the deep fryer on a level and steady surface. Uncoil the whole supply cable. Make sure it does not touch any close
sources of heat.
4. Set the temperature controller to the minimum and connect the fryer to the mains.
5. When grilling food which does not contain fat, we recommend that you grease the grilling grid with a thin layer of oil
or other fat.
6. Select the required temperature according to the food. Information values are provided in the table below.
The red heating indicator (5) will illuminate. Once it turns off, the grilling surface has reached the preset temperature.
7. Put the food on the grilling surface. The dripping bowl will collect juices and fat.
8. Set the temperature controller (4) to the minimum after grilling. If you set it to position 1, the food will be kept warm.
9. Set the temperature controller to the minimum and disconnect the unit from the mains.
Reheating food
Bread and pastry
Fruit and vegetable slices
Fish
Meat
Sea food
WARNING!
Do not use sharp metal objects on the grilling plate and do not cut anything on it. The non-stick surface can
be scratched and damaged. Use wooden or heat-resistant kitchenware.

CLEANING AND MAINTENANCE

Clean the unit after each use to prevent the accumulation of grease, burned-on remnants of food, and unpleasant
smells.
Turn the unit off, unplug the power cord from the wall outlet, and let the unit cool before cleaning and after use.
Do not immerse the power cord, plug, or appliance into water or any other liquid.
Clean the surface with a wet cloth.
Do not use steel wool, abrasive agents or solvents to clean the unit.
Clean the grilling surface with a wooden scraper or other kitchen tool that will not scratch the non-stick surface.
Wash the dripping bowl in tepid water with detergent and rinse in clean water; do not use a dishwasher.
Wipe the removable control module with a damp cloth or absorbent paper. Do not immerse this part into water or
any other liquid. Clean the part on a dry surface so that the part cannot accidentally fall and become damaged.
Let all the parts dry before assembling the accessories.
GE4020
Temperature control position
1
2
2-3
3-4
3-5
4-5
Preparation time (min)
As needed
2-5
2-8
5-10
10-30
3-6
19