Gewiss GW 90 835 Handbuch Seite 26

IN SERVICE
Configuration mode output:
• to save the new settings: press the programming push-button. The programming LED
turns off;
• to exit without saving the settings: wait 10 seconds (from when you last pressed a
button). The end of the configuration mode is signalled when the programming LED turns
off.
When you exit the configuration mode the status of the channels before accessing the
procedure is restored.
In this configuration phase, the messages from the bus are ignored (they are managed
when configuration is exited).
When bus voltage is restored the contacts stay in the state they were in when voltage
dropped.
Maintenance
The device does not require any maintenance. Use a dry cloth if cleaning is required.
26