Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Unpack all parts and remove protective material.
•
Connect the Power Cord to AC outlet. Press the power On/Off knob to switch the system on.
•
Slide the counter weight (25, see depicted below) onto the tone arm, until it reaches the end. Turn clock-
wise until it clicks with pit inside. Twist the counter weight clockwise and backward until it reachse the
white inner line (see below fig. 2). Twist the counter marking until position 1 is reached. Twist the counter
weight anti-clockwise and inward until the appropriate working pressure is adjusted.
•
Remove the stylus cover and make sure the tone arm had been loosened from the tone arm holder.
•
Switch to PHONO (13) and adjust the appropriate PITCH and RPM (27 / 28)
•
Place a record on the platter. Use the spindle adaptor („Puck") if necessary.
•
Gently lift the tone arm from the holder and slowly push it toward the record edge. Let it float over the
desired position/track, then press CUE, to lower the needle.
•
When no record is playing, place the tone arm on the holder.
•
Press CUE to lift the pickup at any point and gently return it to the pickup holder.
Please note: Deactivate the auto-stop function if the auto stop area of your record is smaller than usual.
16
Operation
Anschluss
Phono Deck
Werbung
Inhaltsverzeichnis
