Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Carefully unpack the device and all accessories.
•
Pull the turntable rubber belt (1) to passing the pulley (2):
•
Connect the device to a houshold mains socket using the sup-
plied AC/DC adapter.
•
Turn the VOL/POWER knob clockwise to turn the device on
and adjust the volume.
•
Connect the LINE OUT (rear) with your home stereo or your
PC or any other amplifiers or audio devices using a 3.5mm
audio cable.
•
Slide the FUNCTION switch on the top to the desired mode
(PHONO / LINE IN / USB/SD).
•
Switch the device on and slide the FUNCTION switch to PHONO.
•
Loosen the tone arm from the tone arm rest.
•
Slide the SPEED switch to the RPM appropriate for your record.
•
Place a vinyl record on the spindle and slide the clip onto the spindle. Attach the 45rpm adapter be-
fore, if needed.
•
Move the TONE ARM by hand to the record and slowly lower it to the desired starting point. Press the
PHONO button to activate the turntable
•
At the end of the record lift the TONE ARM and return it manually to the tone arm rest.
Replacing the needle:
•
Gently pull down the tip of the cartridge, pull the cartridge forward, then pull the needle out.
•
To install a new cartridge, position red cartridge with sapphire stylus facing down. Line up the tab on
the back of the needle with the tone arm (fig. 1, below). Insert the cartridge with its front end at a down-
ward angle (fig. 2 below). Lift the front end of the needle upward until it snaps into place.
Operation
Initial Use
Turntable
11
Werbung
Inhaltsverzeichnis
