Installation - Klarstein Lausanne Handbuch

EN
16

INSTALLATION

Select the wall location where you want to hang your electric fireplace heater. Draw
a horizontal line using a level and mark 3 drill holes for the anchor screws. The holes
are for mounting of fireplace and it shall be level so that the fireplace can be mounted
properly and leveled. Marking out the hole positions on wall according to the picture.
Drill 3 holes 8 mm (0.3 in) in diameter and 26mm (1.02 in) deep on the market
locations. For the holes that do not hit stud, use the supplied wall anchor. Install the
wall anchors into the holes and gently tap them into place with a hammer until the
flange of wall anchor is flush with the wall surface
1
2