Cleaning; Calibration; Accessories; Storage - RIDGID micro CM-100 Bedienungsanleitung

Cleaning

• Do not immerse the clamp meter in water. Wipe off dirt with a damp soft cloth. Do not
use aggressive cleaning agents or solutions. Gently clean the display screen with a
clean dry cloth. Avoid rubbing too hard.
• Use only alcohol swabs to clean the test lead connections.

Calibration

The calibration of the meter should be checked once a year to ensure that it performs
according to the specifications. Take to a RIDGID Service Center for calibration check.

Accessories

To reduce the risk of serious injury, only use accessories specifically designed and
recommended for use with the RIDGID micro CM-100 Digital Clamp Meter such as
those listed below. Other Accessories suitable for use with other tools may be
hazardous when used with this meter.
Catalog Number
44748
44758
Further information on accessories specific to this tool can be found in the RIDGID Cat-
alog and online at www.RIDGID.com or www.RIDGID.eu

Storage

The RIDGID micro CM-100 Digital Clamp Meter must be stored in a dry secure area be-
tween -30°C (-22°F) and 60°C (140°F) and humidity less than 85% RH.
Store the tool in a locked area out of the reach of children and people unfamiliar with the
meter.
Remove the battery before any long period of storage or shipping to avoid battery leakage.
The clamp meter should be protected against hard impacts, moisture and humidity, dust
and dirt, extreme high and low temperatures and chemical solutions and vapors.

Service and Repair

Improper service or repair (or calibration) can make the micro CM-100 Digital
Clamp Meter unsafe to operate.
Service and repair of the micro CM-100 Digital Clamp Meter must be performed by a
RIDGID Independent Authorized Service Center.
For information on your nearest RIDGID Independent Service Center or any service or
repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find your local RIDGID contact point.
• Contact RIDGID Technical Services Department at rtctechservices@emerson.com, or
in the U.S. and Canada call (800) 519-3456.
micro CM-100 Digital Clamp Meter
Description
Test Leads with Covers, Black and Red
K Type Adapter and Temperature Probe
WARNING
WARNING
15