Using Three Points; Cleaning; Storage; Service And Repair - RIDGID Micro LM-100 Bedienungsanleitung

micro LM-100 Laser Distance Meter

Using Three Points

Figure 8 – Indirect Measurement Using Three Points
1. Press Indirect Measurement Button
bol will show in the display. The distance to be measured will
flash in the symbol.
2. Press Indirect Measurement Button
bol will show in the display. The distance to be measured will
flash in the symbol.
3. Aim the laser at the lower point (1) and press button 1 to take
the measurement. The measurement will be displayed in first
line.
4. The next distance to be measured will flash.
5. Press ON/Measurement Button
ing the instrument as perpendicular to the line between the
measurements as possible, Press ON/Measurement Button
again to measure the distance result of the horizontal point
(2). The measurement will be displayed in the second line.
6. Press ON/Measurement Button
the laser at the top point, press ON/Measurement Button
12
once, the sym-
again, the sym-
to turn on the laser, keep-
to turn on the laser, aim
Ridge Tool Company
to take the measurement. The measurement will be displayed
in the second line.
7. The result of the calculation is displayed in third line.

Cleaning

Do not immerse the RIDGID micro LM-100 in water. Wipe off dirt
with a damp soft cloth. Do not use aggressive cleaning agents or
solutions. Treat the instrument as you would a telescope or camera.

Storage

The RIDGID micro LM-100 laser distance meter must be stored in
a dry secure area between -10°C (14°F) and 60°C (158°F).
Store the tool in a locked area out of the reach of children and peo-
ple unfamiliar with the laser distance meter.
Remove the batteries before any long period of storage or shipping
to avoid battery leakage.

Service and Repair

Improper service or repair can make the RIDGID micro LM-100
unsafe to operate.
Service and repair of the RIDGID micro LM-100 must be performed
by a RIDGID Independent Authorized Service Center.
For information on your nearest RIDGID Independent Service Cen-
ter or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find your local
Ridge Tool contact point.
WARNING