Description, Specifications And Standard Equipment; Description; Specifications - RIDGID micro CM-100 Bedienungsanleitung

posed metal pipes, outlets, fixtures, etc., which might be at ground potential. Keep your
body isolated from ground using appropriate methods.
• Disconnect the test leads from the meter before making current clamp meas-
urements. This reduces the risk of electric shock.
• When measuring resistance, disconnect all power (remove batteries, unplug
cord, discharge all capacitors, etc.) to the circuit being measured. This reduces
the risk of electric shock.
• After resistance test, the capacitive circuits must be discharged. This will help
protect against electric shock.
• Use extreme caution when working near bare conductors and bus bars. Acci-
dental contact with conductors could result in electrical shock.
• Turn OFF power to the circuit under test before cutting, unsoldering, or break-
ing the circuit. Small amount of current can expose the operator to a shock hazard.
The EC Declaration of Conformity (890-011-320.10) will accompany this manual as a
separate booklet when required.
If you have any question concerning this RIDGID
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find your local RIDGID contact point.
• Contact RIDGID Technical Services Department at rtctechservices@emerson.com, or
in the U.S. and Canada call (800) 519-3456.

Description, Specifications And Standard Equipment

Description

The RIDGID ® micro CM-100 Digital Clamp Meter is a handheld digital instrument with
clamp-on current measuring capability. The unit can measure DC and AC Voltage and
Current, Resistance, Capacitance, Frequency, Temperature, Continuity (audible signal)
and Test Diodes.
The unit has data hold, peak hold and DC Amps zero adjustment functions. Overload
protection and low battery indication are provided in the unit. The unit has a four Digit
backlight LCD.
The Clamp Meter is powered by a 9V battery and has auto power-off function after 20 min-
utes of inactivity.

Specifications

Display ..........................................4-Digit backlight LCD
Clamp Size ...................................1.2" (30 mm) Opening
Overvoltage Category...................CAT III 600 V, CAT II 1000 V
Safety Compliance........................IEC 61010-1, EN 61010-1
Measurement Rate .......................2 per Second, Nominal
Power Supply..................................9V Battery, NEDA 1604, IEC 6F22 or 6LR61
Operating Temperature...................0°C to 50°C (32°F to 122°F)
Weight...........................................0.67 lbs (304 g)
Dimension.....................................9.0" x 3.1" x 1.9" (229 x 79 x 48 mm)
4
micro CM-100 Digital Clamp Meter
® product: