Remington PROluxe H9100 Bedienungsanleitung Seite 4

ENGLISH
• Do not twist or kink the cable, or wrap it round the appliance.
• Do not use the appliance if it is damaged or malfunctions.
• Check the cord regularly for any sign damage.
• Always keep the lid closed while the rollers are heating.
• Ensure there is a roller on each slot while the unit is heating and that each roller is
properly inserted into the base unit.
• DO NOT USE ON ARTIFICAL HAIRPIECES OR WIGS.
• This appliance is not intended for commercial or salon use.
PARTS
1. Velvety flocked rollers
8 x medium 25mm
12 x large 32mm
2. Ceramic heated hinged clips
INSTRUCTIONS FOR USE
• Before use, ensure the hair is clean, dry and tangle-free.
• For extra protection use a heat protection spray.
• Hairsprays contain flammable material - do not use while using this product.
• Section the hair prior to styling. Style the lower layers first.
• Plug the product into the mains power supply.
• The on indicator light will glow once plugged in indicating that the rollers are on.
• CAUTION: the appliance will begin to heat-up as soon as the power supply is switched
on.
• The lid should remain closed until the rollers are ready to use.
• Rollers will be ready in approximately 90 seconds. Allow 3 to 5 minutes for best results.
• When you feel your setters are ready, open the lid for 1 minute and begin use.
TO CURL
1. Starting with the lower sections of hair, take a section the width of a roller.
2. Start by using the medium sized rollers. Slide the roller up out of the base unit using the
clip.
3. Remove the clip from the roller.
4. With the section of hair in one hand and the roller in the other, place the roller at the
ends of the hair and wind the hair around the roller towards the root ensuring the hair is
always taut.
5. Secure the hair in place using the clip.
6. Repeat steps 3-5 until all of your hair is in rollers.
4
3. Cool touch ends
4. On indicator light
5. Base unit