HANSGROHE AXOR Carlton 17030 series Montageanleitung Seite 6

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over the
threaded base and tighten the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the angle valves; cold
right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Technical Data
This mixer series-produced with EcoSmart
(flow limiter)
Rate of flow with EcoSmart:
Rate of flow without EcoSmart:
Operating pressure:
Recommended operating pressure:
Test pressure:
(1MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test cetificate 17030XXX:
Hansgrohe single hole mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
If the continuous flow heater makes any problems or there
comes not enough water, the EcoSmart (flow limiter 6a)
located behind the mousseur must be removed.
To simplify installation pressure hoses no. 13098000 are
available.

English
Spare parts (see page 3)
1
2
3
4
5
6
7
8
8.1 pull knob
8.2 pull rod
9
XXX = Colors
000 chrome plated
090 chrome/gold plated
7 l/min 0,3 MPa
14 l/min 0,3 MPa
max. 1,0 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80° C
65° C
WRAS
knob for cold water
knob for hot water
spout for sink
spout for bidet
washer
aerator cpl.
stop unit
pull rod cpl.
fixation cpl.
17291XXX
17292XXX
96051XXX
96055XXX
92646000
13085XXX
94149000
92620XXX
94066XXX
94067000
13961000