Teleco TVPLA868CC2EN Bedienungsanleitung Seite 4

MOTOR CONFIGURATION: Identify the correct product application from the 3 given below and follow the relative configuration procedure.
Attention: if the wrong application is selected, the configuration procedure must be repeated for the correct application.
Pergola with 1 motor
2.1
1. MOTOR CONFIGURATION
DIP4=OFF
DIP5=OFF
=
P1
CLOSE
2. SELF-LEARNING OF LIMIT SWITCHES
< 1 s
+
P1 P2
Press P1 and P2 simultaneously twice in quick succession and
hold them the second time for 5 s
ON
DO NOT change the DIP configuration. This change would be signalled by a new intermittent sound and the flashing of L3, and would require a new configuration procedure.
1 2 3 4 5 6
( 5 s)
+
P1 P2
Press P1 and P2 simultaneously
and hold for 5 s
=
P2
OPEN
If the direction is wrong, invert the motor wires.
(start from and intermediate point of the run)
( 5 s)
+
P1 P2
...
L3 flashes
...
Continuous sound
M
24Vdc
Opening
complete
opening
complete
closing
...
LED L1 flashes during motor movements.
4
Check that movement
stops when the limit switch
is reached (L1 ON)
L1 If it doesn't, change the
Closing
threshold as per PAR 2.4
(page 7) and repeat.
L1
complete
opening
complete
closing
...
...
...