Teleco TVPLA868CC2EN Bedienungsanleitung Seite 15

6.1
TROUBLESHOOTING (what to do IF...)
Problem
At power-on, the control unit does not move the motors and emits no warning.
L3 flashes and an intermittent sound starts after configuration.
The configuration procedure does not start upon pressing P1 and P2 twice.
During the manual movement test in the configuration procedure, the motors do
not stop automatically at the limit stop.
There's no continuous beep during transmitter memorization.
It is impossible to memorize a transmitter.
After configuration, the engine stops and invert the direction.
The motor stops or there is abnormal functioning of the motor.
6.2
Replacing the control unit
In the event of a defective control unit, if the provided memory (see below) is
still working and the revision of the board is > 9.x, it may be replaced without
losing the configuration parameters.
To do this, the control unit must not be powered:
• insert the memory card of the defective control unit into the new one;
• set the DIP switches of the new control unit as they were in the old one;
• switch the system on.
M2
M1
Memory
Solution
The system needs to be programmed, see section 2.
Repeat the procedure. At the end of it DO NOT change the DIP4-5 setting.
P1 and P2 must be pressed simultaneously. There must be no more than 1 second
between pressing the first and the second time.
Change the current threshold (section 2.4) before continuing with configuration.
There must be no more than 1 second between pressing the buttons.
The radio code is already memorized or the memory is full.
Remove any obstacles that block the movement.
Check the encoder signal wiring.
6.3
Quick learning of limit switch
If the following have been already programmed
• motor control mode
• the correct motor direction
• at least one transmitter for each of the independent motor output
• current threshold to be applied
it is possible to carry out the SELF-LEARNING OF LIMIT SWITCHES without
accessing the control unit.
Test the movement and the direction of the motors by
means of the memorized transmitter, after this keep the
button P3 of the transmitter pressed for 10 s.
complete
opening
complete
closing
...
• Pergola with 2 synchronized motors: Together MOTOR 1 and MOTOR 2
• Pergola with 2 independent motors: MOTOR 1 first, then MOTOR 2
15
Memorized
P3
complete
opening
complete
closing
...
...
( 10 s)
...