Teleco TVPLA868CC2EN Bedienungsanleitung Seite 10

Radio code deletion
3.2 1.1
If the system is configured as pergola with 2 independent motors, use P1 to delete associations with motor 1 and P2 for motor 2.
Carry out deletion with either P1 and P2 if the code is associated with both motors.
In the other configurations deletion is possible using either P1 or P2.
TYPE OF DELETION
SINGLE RADIO CODE
Press P1 or P2 (**) 5 times and hold. The buzzer emits an intermittent sound. Press the button of the transmitter relative to the code to be deleted within 10
seconds. Successful deletion is indicated by a continuous sound of the buzzer.
ALL THE RADIO CODES
Press P1 or P2 6 times and the sixth time hold for 10 seconds. The buzzer emits a fast intermittent sound. Release when the sound becomes continuous.
* The buzzer will make a beep each time the button is pressed.
3.3 1.1
Remote memorization of other radio codes
Note: The button P3 is located inside the transmitter. The added radio code will have the same functions as the
code used for memorization. This procedure is compatible with any type of transmitter.
Memorized Memorized
P3
continuous
sound
< 5 s
Press button P3 of the memorized transmitter and hold. The buzzer emits a
continuous sound. Press a button relative to an already memorized code. The
buzzer stops for 1 second and then starts the continuous sound again. Press the
button relative to the new code to be memorized. Successful memorization is
indicated by the intermittent sound of the buzzer.
P1 or P2 **
*
5x
*
6x
** According to the motor control mode
New
continuous
sound
1 s < 5 s
...
HOLD
Press the button of the transmitter
relative to the code to be deleted.
intermittent
(10 s)
sound
3.4 Remote deletion of a radio code
Note: The button P3 is located inside the transmitter. If the radio code was
associated with both motors, carry out the deletion twice.
Memorized
...
P3
x 3
Press the button P3 of the memorized transmitter 3 times and hold. The buzzer
emits a slow intermittent sound. Press a button relative to the code to be deleted
within 5 seconds. Upon completion of deletion, the buzzer will stop.
10
...
To be deleted
...
intermittent
sound
< 5 s
P1 or P2
continuous
sound
continuous
sound