Teleco TVPLA868CC2EN Bedienungsanleitung Seite 2

INDEX
1. Connections, adjustments and control unit warnings
2. MOTOR CONFIGURATION
2.1 Pergola with 1 motor
2.2 Pergola with 2 synchronized motors
2.3 Pergola with 2 independent motors
2.4 Setting of the current threshold during configuration
3. TRANSMITTERS
3.1 Radio codes memorization
3.2 Radio codes deletion
3.3 Remote memorization of other radio codes
3.4 Remote deletion of a radio code
4. SENSORS
4.1 WIND sensor
4.2 TEMPERATURE sensor
4.3 SNOW condition
4.4 RAIN sensor
4.5 Modification of the alarm automatic angles
5. CHANGE OF THE PRESET ANGLES -------------------------------------------------
6. FURTHER DETAILS
5.1 Troubleshooting (what to do IF...)
5.2 Replacing the control unit
5.3 Quick learning of limit switches
7. Technical specifications
Accessories
WARNINGS
The product at issue must be installed, commissioned and maintained only by licensed and authorised people,
respecting the laws concerning the automatic covers. The system is powered by 24V
power supply make sure that the sensors and motors are correctly connected. A faulty connection of the motors (polarity
inversion) could damage them together with the connected mechanical elements. The power supply must supply the required
voltage and current according to the characteristics of the system. The power supply must be compliant with IEC60950-1
and must be protected against the short-circuit and over-voltage. Use a 2x1.5mm cable to connect the motors and the
control unit for length up to 6m, or 2x2.5mm cable for longer segments. PRODUCT DISPOSAL: at the end of this product's
useful life, it must not be disposed of as domestic waste, but must be taken to a collection centre for waste electrical and
electronic equipment. To prevent infiltration of water, wire the product as follows:
The manufacturer, Teleco Automation s.r.l, declares that the type of radio equipment is compliant with Directive 2014/53/
EU. The full text of the EU compliance declaration is available at the following Internet address: www.telecoautomation.
com/ce. In the view of a constant development of their products, the manufacturer reserves the right for changing technical
data and features without prior notice.
-----------------------------------------------------------
---------------------------------------------------------------------
-------------------------------------------------------------------------------
-----------------------------------------------------------
-----------------------------------------------------------
-------------------------------------------------------------------------------
--------------------
. Before the connection to the
page 3
pages 4 - 7
pages 8 - 10
pages 11 - 13
page 14
page 15
page 16 - 17
page 18