Installation Warnings - GiBiDi BA24 Bedienungsanleitung

BA24
• COSTA choice with N.C. contact or 8K2 resistive.
• Anti-crushing enabling (motion inversion for 2 seconds and stop) or amperometric detection for limit switch.
• Specific menu for the exclusion of the accessories not used (picture 1, picture 2 and safety devices).
• Possibility to program: automatic closing, fast closing, pre-flashing, hammer stroke, final closing and opening
stroke, courtesy light, ending movement additional time, flashing light (both flashing and fixed), external clock
management with three different modes, number of cycles for scheduled maintenance, installer code and
number of performed cycles.
• Time self-learning.
INSTALLATION
Use glands adequate to ensure proper mechanical connection of cable and maintain the box protection degree IP55.
(2)

INSTALLATION WARNINGS

• Before proceeding with the installation, fit a magnetothermal or differential switch with a maximum capacity of
10A upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3 mm.
• To prevent possible interference, differentiate and always keep the power cables (minimum cross-section
2,5 mm²) separate from the signal cables (minimum cross-section 0.5 mm²).
• Make the connections referring to the following tables and to the attached screen-print. Be extremely careful to
connect in series all the devices that are connected to the same N.C. (normally closed) input, and in parallel all
the devices that share the same N.O. (normally open) input. Incorrect installation or improper use of the
product may compromise system safety.
• Keep all the materials contained in the packaging away from children, since they pose a potential risk.
• The manufacturer declines all responsibility for improper functioning of the automated device if the original
components and accessories suitable for the specific application are not used.
• After installation, always check carefully proper functioning of the system and the devices used.
• This instruction manual addresses people qualified for installation of "live equipment". Therefore, good technical
knowledge and professional practice in compliance with the regulations in force are required.
• Maintenance must be carried out by qualified personnel.
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
• This control unit may only be used for the purpose for which it was designed. Check the aim of the final use
and make sure that all safety measures are taken.
• If the control equipment is installed on doors or leaves with wicket door, make sure that in case the wicket door
is open, the equipment is not allowed to work.
• Use of the product for purposes different from the intended use has not been tested by the manufacturer,
therefore any work is carried out on full responsibility of the installer.
• Mark the automated device with visible warning plates.
• Warn the user that children or animals may not play or stand around near the gate.
• Appropriately protect the danger points (for example, using a sensitive frame).
• The only control equipment does not guarantee anti-crushing safety. Please make sure that the security
devices connected to the control equipment are suitable for this purpose.
27
UK