Operation; Ec Declaration Of Conformity; Maintenance - Makita 6802BV Betriebsanleitung

Reversing switch action (Fig. 6)
CAUTION:
• Always check the direction of rotation before opera-
tion.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever to the
i
position for clockwise rotation or the
for counterclockwise rotation.

Operation

Fit the screw on the point of the bit and place the
point of the screw on the surface of the workpiece to
be fastened. Apply pressure to the tool. Start the tool
slowly and then increase the speed gradually. With-
draw the tool as soon as the clutch cuts in.
CAUTION:
• Use the proper bit for the head of the screw that you
wish to use.
• When fitting the screw onto the point of the bit, be
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
• Do not continue unnecessary clutching operation.
NOTE:
Make sure that the bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.
When using insert bit (Fig. 7 & 8)
Fit together the insert bit and magnetic bit holder.
Install a locator assembly for an insert bit.
Then adjust depth setting. Initially, adjust the locator
assembly to create a distance of approximately 1 mm
from the tip of the locator to the base of the screw
head. Continue adjusting until the proper depth set-
ting is obtained by following the method of "Depth
adjustment".
To remove the bit, pull the magnetic bit holder firmly.
Hold the magnetic bit holder in your hand and grasp
the bit with a pair of pliers. Pull the bit out of the mag-
netic bit holder. Sometimes, it helps to wiggle the bit
with the pliers as you pull.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.
6
For European countries only
The typical A-weighted sound pressure level is 79 dB (A).
Uncertainty is 3 dB (A).
The noise level under working may exceed 85 dB (A).
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
j
position
These values have been obtained according to
EN60745.
We declare under our sole responsibility that this product
is in compliance with the following standards of standard-
ized documents,
in accordance with Council Directives, 89/336/EEC and
98/37/EC.
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
Noise and Vibration
– Wear ear protection. –
2
.
EC-DECLARATION OF CONFORMITY
EN60745, EN55014, EN61000
Yasuhiko Kanzaki
Director
ENG003-2
ENH101-5
CE 2005