Sanus FMK056 Montageanleitung Seite 18

7-2
Solid Concrete and Concrete Block Mounting
1. Level wall plate [01] and mark the hole locations.
2. Drill pilot holes as illustrated.
3. Insert lag bolt anchors [31] and then insert lag bolts
[29].
4. Tighten the lag bolts [29] only until the washers [30] are
pulled fi rmly against the wall plate [01].
CAUTION: Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property
damage:
 Mount wall plate directly onto the concrete surface.
 Pilot holes MUST be drilled to a depth of 63.5 mm (2.5
in.), using a 13 mm (1/2 in.) diameter drill bit.
 Be sure the anchors [31] seat fl ush with the concrete
surface.
 Never drill into the mortar between blocks.
 Do not over-tighten the lag bolts [29].
2
63.5 mm
(2.5 in.)
18
CAUTION:
3 & 4
63.5mm
2.5 in.
1
[01]
[31]
[29]
13mm
13mm
(1/2 in.)
(1/2 in.)
[31]
[31]
[30]
6901-002058 <01>