Sanus FMK056 Montageanleitung Seite 17

Attach Wall Plate to Wall
Wood Stud Mounting
1. Locate studs. Verify the center of the stud with an awl or
thin nail or use an edge to edge stud fi nder.
2. Level the wall plate [01] and mark the hole locations.
3. Drill pilot holes as illustrated.
4. Tighten the lag bolts [29] only until the washers [30] are
pulled fi rmly against the wall plate [01].
CAUTION: Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property
damage:
 Pilot holes MUST be drilled to a depth of 63.5 mm (2.5
in.), using a 5.5 mm (7/32 in.) diameter drill bit.
 Do not over-tighten the lag bolts [29].
 Any material covering the wall must not exceed 16 mm
(5/8 in.).
2
[01]
4
6901-002058 <01>
13mm
5.5mm
(1/2 in.)
(7/32 in.)
[30]
[29]
CAUTION:
1
3
< 16 mm
(5/8 in.)
40.6 - 61 cm
(16 - 24 in.)
63.5 mm
(2.5 in.)
63.5mm
7-1
2.5 in.
17