Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing Wheels; Replacing A Fuse - Levita LT61B Gebrauchsanweisungen

Ride-on rasenmäher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6.3.2 Replacing wheels

grease on the axle and after refitting the wheel; carefully refit the washer (2) and the snap
ring (1).
any differences in their external diameter does not exceed 8-10 mm; on the contrary, to
prevent an uneven cut it will be necessary to adjust the alignment of the cutting deck.
6.3.3 Replacing and repairing tires
All puncture repairs or replacements will have to be carried out by a tire repair expert in
accordance with the methods for the kind of tire used.

6.3.4 Replacing a fuse

The electric system and the electronic card are protected by a fuse. When it blows the
machine stops, so in this case:
1
The fuse capacity is indicated on the fuse.
1. Place the machine on a flat surface and put blocks
under a load-bearing part of the frame on the side of the
wheel to be changed;
1
2. using a screwdriver, remove the snap ring (1) and the
washer (2);
2
3. pull out the wheel
If you have to replace one or both rear wheels, make sure that
2
1.
remove the engine housing
(1) using a hand;
2.
replace the fuse (2) with
another one with the same capacity
(10A);
3.
remount the engine housing (1).
-95-
Smear some waterproof

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Levita LT61B

Inhaltsverzeichnis