Levita LT61B Gebrauchsanweisungen Seite 86

the cutting deck put at its highest position.
To start the forward movement:
1. put the accelerator control between the «SLOW» and «FAST» positions;
2. push the pedal right down (☛4.2) and put the gear change lever in 1st gear (☛4.4).
3. release the pedal gradually to begin the movement.
Reach the desired operating speed using the accelerator and gear lever. To change gear, the
clutch must always be used by pushing the pedal (☛4.2).
engagement may cause tipping up and loss of control of the vehicle.
moving with the gear shift more than 1/3 of the way towards «F» to avoid suddenly
engaging drive which could cause the vehicle to tip and loss of control.
5.4.3 Braking
To brake:
1. first slow down the machine by reducing the engine speed;
2. push the pedal right down (☛4.2) to lower the speed even more until the
machine stops.
3. Move the speed gear shift (☛4.4) to idle «N» to permit gradual motion.
5.4.4 Retromarcia
1. When the machine has stopped, put it in reverse by moving the lever sideways to
position «R» (☛4.4);
2. gradually release the pedal to engage the clutch and then begin moving in reverse.
When moving the machine, the blade must be disengaged and
The pedal must be released gradually as sudden
Do not suddenly release the pedal and do not start
Reverse MUST be engaged only when the machine
-86-
.
HAS STOPPED