Interventions On The Machine - Levita LT61B Gebrauchsanweisungen

6.2.3 Battery
To ensure long life to the battery it is essential to keep it carefully maintained.
The machine battery must always be charged:
−
before using the machine for the first time after purchase;
−
before leaving the machine for a prolonged period of disuse;
−
before starting up the machine after a prolonged period of disuse.
Failure in following the procedure or in charging the battery could permanently damage the
battery elements.
A flat battery must be recharged as soon as possible.
voltage. Other recharging systems can irreversibly damage the battery.
1

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
Recharging must be done using a battery charger at constant
The machine comes with a connector (1) for recharging, near the
battery, to be connected to the connector for the battery-charger
supplied (if included) or available on request (☛ 9).
This connector must only be used for connecting to the
battery charger delivered by producer.
If the cut is uneven, check the tire pressure.
If this is not sufficient to achieve an even cut,
please contact your Dealer for the adjustment of
the alignment of the cutting deck.
-94-