Emptying The Grass-Catcher; End Of Work - Levita LT61B Gebrauchsanweisungen

5.4.6 Emptying the grass-catcher

3. disengage the blade (☛4.6);
4. engage the parking brake on slopes;
5. hold onto the rear handle and tip up the grass-catcher to empty it;
otherwise the engine stops
5.4.7 Unblocking the collector channel
the collector channel gets blocked (due to accumulated grass cuttings filling up the grass-
catcher or an excessively high speed with relation to the quantity of grass cuttings), you need
to:
1. stop forward movement immediately, disengage the blade and stop the engine;
2. remove the grass-catcher;
3. remove the accumulated cuttings, reaching them from the exit of the collector channel.
5.4.8 End of mowing
When you have finished mowing, disengage the blade, lower the engine speed and ride the
machine with the cutting deck in the highest position.

5.4.9 End of work

Once you have finished mowing, stop the machine and engage the parking brake.
1. shift the accelerator lever to «SLOW»;
2. switch off the engine by turning the key to «STOP».
The grass-catcher is full when the grass cuttings
remain on the lawn. If you continue mowing with
the grass-catcher full, it may block the collector
channel. To empty the grass-catcher:
1. lower the engine speed;
2. go into neutral (N) (☛4.4) and stop the
This operation can only be done with the blade disengaged,
This job must only be performed with the engine Turned off. If
Always take out the ignition key before leaving the machine
unattended
To keep the battery charged, do not leave the key in the«ON»
position when the engine is not running.
machine's forward movement;
-88-