Closing The Door; Replacing The Lamp; Installation - Electrolux EN3601MOW Benutzerinformation

32 www.electrolux.com
Problem
If the advice does not lead to
the desired result, call the
nearest brand-mark service.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

8.3 Replacing the lamp

The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from the
mains socket.
1. At the same time, with the fingers
expand up and down the transparent
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
Possible cause
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu-
lation in the appliance.
2. Replace the lamp with one of the
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Solution
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
cover and unhook it in the direction of
the arrows.
1
2
1
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
Make sure that the light comes on.