Connect the power cable to a 230V, 13 amp
supply that is located in a safe, dry area.
•
Once the power is on, the Pressing Switch on the heater is used to control the two heat settings. (I) for
1800W. The 0-position is off.
•
The Remote control is also used to control the two heat settings. (I) for 1800W. The 0-position is off.
•
Although the patio heater is shower proof, do not use when raining or in wet conditions.
•
Always disconnect the power cable from the electrical supply, when the patio heater is not in use.
Care and maintenance
•
When disconnected from the electrical supply, clean the outside of the patio heater with a damp cloth. Never
use corrosive or solvent cleaners or immerse in water.
•
Any maintenance or repairs including replacing the halogen tube should only be carried out by a qualified
electrician or by a recommended service center.
Technical specification
•
Power supply 230V, 50Hz
•
Wattage max 1800W
•
Net weight 2.8 kg
•
Insulation class I
•
The Pull-Off Switch is used to control the power of the appliance.
www.sunred.nl