Sunred HWM18 Bedienungsanleitung Seite 3

Please read these instructions carefully before using your new halogen heater
Unpack the halogen heater, making sure that all the items are present and that there are no components left in
the box and that the heater head is free from any packaging material.
Using the detailed drawings, follow the steps to assemble your halogen heater.
Do not connect the halogen heater to the electrical supply until all the assembly is complete.
Do not connect the halogen heater to the electrical supply if any of the components or the power cord is
damaged in any way.
If in doubt contact your supplier.
Warning

These appliances must be earthed.

Before installing or replacing the bulb, the appliance must be always be disconnected from the 230V supply.

The appliance must be disconnected from the 230V supply before the lid is opened.

The appliance must be installed exclusively in perfect horizontal position.
Installation
This Patio Heater is built with the best quality components in accordance with the prevailing legal regulations and
certified for safety in use. For best results from the appliance please ensure that the installation is done by a qualified
electrician in accordance with the following instructions and taking full account of current regulations. When using the
heater, please carefully follow the instructions and recommendations below.
Connection to 230 Volts Power Supply

It is important to ensure that the electricity supply is of adequate capacity for the electrical load required by the
appliance being installed.
 These appliances must be earthed.
Installation to Wall
a) When fixing the heater to a wall, ensure hinges are in the underside so that the lid hands down in the open
position.
b) Minimum required distances:
 250mm from the side wall

500 mm from the ceiling

Installation height above 1.8M

The heater must be fixed to a wall with the bracket supplied to allow adequate ventilation.

Never fix or place heater near flammable or combustible materials.

Generally heaters must be placed at a safe distance (clear space) of at least 2.0m from combustible materials
and glass walls. If installed in workshops or garages where inflammable or combustible paints are used, the
heater must be installed at a distance of at least 4.0m from the source of danger.

If the heater is mounted in areas where spray painting of any description is taking place, it should not be used
during painting operations.

Never use the heater in particularly dusty and explosive areas.
www.sunred.nl