FUNKTION
BYPASS
Separated
bypass line
26
Auto bypass on
Bypass mode
Bypass active in
stand-by
Bypass
frequency
tolerance
Bypass min.-
max. threshold
Bpass
intervention
sensibility
Bypass
Switching delay
without
synchronisation
Eco mode
sensibility
Eco mode
min.-max.
threshold
BESCHREIBUNG
USV Bypass separat ausgeführt
USV startet und versorgt die
Last sofort nach Wiederkehr der
Bypasseinspeisung
Auswahl der Betriebsart des
Bypassanschlusses
Lastversorgung über Bypass
mit Wechselrichter in Stand-by
Auswahl der akzeptierten
Frequenz zur Umschaltung auf
Bypass und für die
Synchronisation des USV-
Ausgangs
Auswahl des akzeptierten
Spannungsbereiches für
Umschaltung auf Bypass
Wechselrichter Ausgang Sinus
Empfindlichkeitssteuerung
Verzögerung der Umschaltung
auf Bypass ohne Synchronität
zwischen Netz und WR-
Ausgang
Auswahl der Eingriffssensibilität
während des ECO-Betriebs
Auswahl des
Spannungsbereiches für ECO
Betrieb
VOREIN-
MÖGLICHE KONFIGURATIONEN
STELLUNG
Common bypass line
Separated
Separated bypass line
bypass line
Disable
Disable
Enable
Enabled / High sensitivity
Enabled / Low sensitivity
Enabled /
Disabled with input/output
High
synchronisation
sensitivity
Disabled without input/output
synchronisation
Disable (load
Disable (load not supplied)
NOT
Enable (load supplied)
supplied)
±0,25%
±0,5%
± 5%
±0,75%
±1 - ±10 @n 1% step
Low: 180 ÷ 220 @ 1 V step
Low: 180 V
High: 240 ÷ 264 @ 1 V step
High: 264 V
0,5 ÷ 10 ms @ 0,1 ms
0,5 ms
0 (Transfer disable)
10 ms
10 ÷ 100 ms @ 10 ms step
Low
Normal
Normal
High
Low: 180 ÷ 220 @ 1 V step
Low: 200 V
High: 240 ÷ 264 @ 1 V step
High: 253 V