Replacing The Lamp; Installation; Closing The Door; Electrical Connection - Atag KA2411L Benutzerhandbuch

Problem
Upper or lower square is
shown in the tempera-
ture display.
DEMO appears on the
Display.

Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center.

Closing the door

1. Clean the door gaskets.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the door, you must ensure that it is
made unusable to prevent young
children being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
Possible cause
An error has occurred in meas-
uring the temperature.
The appliance is in demonstra-
tion mode (DEMO).
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the Light button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Climate Ambient temperature
class
ST +16°C to + 38°C
T +16°C to + 43°C

Electrical connection

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
23
Solution