Replacing The Lamp - Atag KA2411L Benutzerinformation

Problem
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
Water flows on the rear plate
of the wine cooler .
Temperature cannot be set.
dEMo appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the wine
cooler compartment too
low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The door is not closed cor-
rectly.
The FastFreeze function is
switched on.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
The FastFreeze or Shop-
ping function is switched
on.
The appliance is in demon-
stration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.

Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Solution
Refer to "Closing the door".
Refer to "FastFreeze function".
The compressor starts after a
period of time.
This is correct.
Switch off FastFreeze or Shop-
ping manually, or wait until the
function resets automatically to
set the temperature. Refer to
"FastFreeze or Shopping func-
tion".
Keep the Functions button
pressed for approximately 10
seconds until a long sound is
heard and display shuts off for
a short time.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
25