Klippan kiss Bedienungsanleitung Seite 19

Klippan Isofix Safety System 2 User instruction
Parts of the seat
2.1 Head Support
2.2 Seat
2.3 Integrated handles
2.4 Inserts
2.5 Frame
2.6 Belt Guides
2.7 Isofix adjuster
2.8 Isofix
Right angle for 0 – 3 years
3.1 I (0 – 1 years)
3.2 II (1 – 2 years)
3.3 III (2 – 3 years)
Fitting instruction – Preparations for fitting
1. Remove the seat itself from the base by pulling the handle (by the arrow) outwards.
2. Adjustment of internal belt height. Pull out the internal belt to their fullest extent. Release the shoulder belt tension from
the back of the seat. Pull them out first , then move them to their new height. Reattach them properly in the tensioner.
NB: Make sure that they have not twisted together. If the internal belt is too short for the child, release the belt loop in
front of the seat from the plastic shell.
3. The seat is supplied a comfort insert for newborns. This insert consists of a seat and a back section. The seat section can be
used approx. up to 3 months and the back section to approx. 9 months of age.
4. When using the seat for children under 9 kg, the soft base cap (A) shall be used. If the childs weight is over 9kg , the
headrest (B) must be fitted on the base
Fitting instruction – Headrest for child over 9kg
5. Child under 9kg shall travel with the seat in angle position 1
6. Headrest, for child over 9kg. is fitted on the base so that the left heel is first pushed down (A)...
7. ... Push out the right side (B) andn push down the heels in the tracks. Bend carefully with a screwdriver if it is too tight.
8. ... Push down the right side (D) so that the heels grips. End the mounting by pushing out the left side (E) and down (F) then
the heels goes in right position. (By bending out the heels with a screwdriver you can remove the headrest from the base).
Fitting instruction – Use of KISS 2
9. Position of the child into the seat.
Push the button (A) to pull out the child seat´s own belts. Pull the shoulder belts as far as possible (B). Push the red button (C)
on the buckle to open the belt, then put them to either side (D) Fold the crotch strap forwards (E) with the buckle and its safety
sleeve. Place the child in the seat (F) with the crotch strap between the child´s legs. Push the straps locking clasps (G) together
as shown in the illustration, then click them into the buckle (H) . If required, adjust the height of the belt at the back (as shown
in illustration 33) Finally, tension the child seat´s belt by pulling the strap (I) on the front of the seat, what is known as the one
–handed tensioner.
NB. If the belt is too short, release the loop (in the end of strap I) from the plastic shell.
2.9 Indicator
2.10 Wheels
2.11 Indicator
2.12 Belt Guides
2.13 Rocking Stop
2.14 3 Positions
2.15 Support leg
2.16 Push handle
Maximum comfort and safety for three years.
3.4 3.4
Clear markings make it easy to set your child
seat at the right angle as your child grows.
19