Technical Data - Lelit PG036 Handbuch

PG036
COMPONENTS:
1. Safety cap
2. Wand
3. On/off switch "Iron"
4. Boiler switch
5. Low water indicator light
6. Cable and plug
7. Regulator for steam outlet
8. Automatic system switch
USER INSTRUCTIONS:
1. Remove the machine from its packing and make sure all the packing parts have been taken off (including the
protection bags).
2. Lay the machine on a steady and flat surface next to a wall-socket (1,5 mt maximum).
3. Plug in the optional accessory's plug (steam iron PG036/1, steam brush PG036/5, steam gun PG036/6) into the
socket for steam iron and solenoid valve control (9) and the accessory's steam hose into its angle connection (10) and
fix it by a hose-clip band (to connect the second accessory repeat the same operation with the second socket and the
second angle connection). Put the supplied wand in its own seat (2) and hook up the steam hose and the cable.
4. Before beginning any operation, make sure that the tap placed on the side is closed and the "L" joint is screwed up
with the outlet downwards.
1.1 Manual filling operating – switch (8) off "O":
1. Open the cap (1) and fill the boiler with max. 3,7 litre water, make sure you do not overspill the tank and close the
cap (1) carefully.
2. Connect the plug (6), switch the boiler button (4) and the on/off switch (3) on.
3. Set the temperature regulation knob (14) of the iron plate on "cotton" (marked on the knob with "
4. Wait that the boiler button light (4) goes off, it takes about 15 minutes (while ironing the light comes on).
5. The machine is ready for use.
6. Press the steam button (12-14 or 15) of the accessory.
7. It is possible to regulate the steam quantity by the regulator for steam outlet (7).
8. In case that during ironing the steam stops and the low water indicator light (5) comes on, there is not enough
water in the tank (the tank is not totally empty). To start ironing again, switch the boiler switch (4) off. By pressing
the steam button, make sure the iron does not release steam anymore, switch the on/off switch (3) off, take the
plug (6) off, slowly unscrew the cap (1) and let the internal steam out, wait for it some minutes and fill the tank
with warm water.
9. When you first press the steam button (after having turned the boiler on and depressed the steam button on the
iron) you might notice a decrease in pressure. This is because the tank has air in it. In order to have plenty of
steam (after you have depressed the iron) wait until the pressure goes back up to the maximum level before you
begin.
1.2 Automatic filling operating – switch (8) on "I":
1. Put the two hoses of the Automatic System in a tank/can filled with water only.
2. Make sure that all the switches are off.
3. For a correct machine operating, the tank/can must always contain water.
4. Connect the plug (6) to the electric net.
5. Switch the automatic system button (8) on the position "I". After 5 seconds the pump begins with the water filling
6. When the required water level in the boiler has been reached, the pump stops working and the buttons (3 and 4)
can be switched on.
7. All through the use the automatic reactivation of the pump is normal.
8. Set the temperature regulation knob of the iron plate on "cotton" (marked on the knob with "
9. Keep waiting for the turning off of the boiler button light (4), it takes about 15 minutes (while ironing the light turns
on).
10. The machine is ready for use.
11. Press the iron steam button.
12. Regulate the steam quantity by the knob (7).
13. When you first press the steam button (after having turned the boiler on and depressed the steam button on the
iron) you might notice a decrease in pressure. This is because the tank has air in it. In order to have plenty of
steam (after you have depressed the iron) wait until the pressure goes back up to the maximum level before you
begin.

TECHNICAL DATA:

Working voltage: 220-230 V 50 Hz
Nominal capacity of the boiler: 5 Litres
Boiler power 1 heating element: 1500 W
Service pressure: 3,5 Bar
Maximum pressure: 5,5 Bar
Pag. 4
9. Socket for steam iron and solenoid valve control
10. Angle connection
11. Steam iron PG036/1 (not included)
12. Steam button (PG036/1)
13. Steam regulation knob (PG036/1)
14. Steam button of steam brush PG036/5 (not included)
15. Steam button of steam gun PG036/6 (not included)
English
ooo
").
OOO
")