Omron BF206-BT Bedienungsanleitung Seite 15

HBF-206IT-E_A_M.book Page 15 Wednesday, March 10, 2010 12:04 PM
Transferring the Data
1.
Display the measurement results.
• Transferring data after taking a
measurement:
Follow the steps in Section 5, to display the
measurement results.
• Transferring data without taking a
measurement:
Follow the steps in Section 7, to display the
results for the last measurement.
• Transferring data when using GUEST
mode:
You can also register a device after taking a
measurement using GUEST mode.
Follow the steps in Section 5, to display the
measurement results.
Note: When using GUEST mode, you
cannot send results stored on the
unit, you can only send the
measurement results for the current
measurement.
2.
Enable data transfers.
Set the application on the destination device
to transfer mode.
For details, refer to the manual provided with
the application you are using.
About Data FULL Indicator
Up to 30 sets of measurement results can be stored for each personal
profile number.
If the number exceeds 30, the oldest results are deleted.
If the Data FULL indicator blinks or remains lit, transfer data to a device
as soon as possible to avoid losing measurement results.
blinks: 24-29 sets of measurement results have been stored.
lit: 30 sets of measurement results have been stored.
Note: The Data FULL indicator is not displayed when only 0 to 23 measurements results are stored.
8.Transferring the Data
3.
Press the UPLOAD button.
The display changes to the data transmission
screen, and the unit starts transferring the data.
Note: If you press the UPLOAD button
while the data is being transferred,
the transfer will be stopped and the
display will revert to the previous
screen.
If the data is sent successfully, the "OK"
indicator lights and the alarm will beep (Blip!
Blip!).
Note: If the data transmission fails, then
the "Err" indicator lights and the
alarm will beep three times (Beep!
Beep! Beep!).
Check the application on the
connected device, then repeat the
procedure from step 2 to try again.
The screen will return to the screen displayed
before data transmission started after
10 seconds.
4.
Press the WEIGHT/OFF button to
turn off the power.
Data FULL Indicator
EN
15