REPAIR AND mAINTENANCE
Turn power "OFF" before conducting any maintenance procedures.
q Adjusting Brakes
1
Thread brake lever adjuster
1/4 to 1/2 turn until desired
brake adjustment is attained. If
it still needs further adjustment,
proceed to step 2.
q Front Wheel Replacement
1
Loosen brake cable bolt.
2
If too tight or has too much
slack, loosen brake cable and
adjust accordingly.
2
Loosen locknuts. Remove
wheel and install replacement
wheel.
3
Inspect brake pads (A) for
proper alignment against wheel
or excess wear. To realign
brake pads, loosen fixing nut (B)
and adjust pad to contact rim.
Retighten and test. Readjust as
needed.
5
Note: Front wheel hardware
sequence
9-1
9-3
9-2
9-2
9-6
9-5
9-1
9-2
9-2
Right (Throttle)
9-3 - Spacer
9-2 - Washer
Fork
9-2 - Washer
9-1 - M10 locknut
Middle
9-6 - Front axle bolt
Left (Brake)
9-5 - Spacer
9-2 - Washer
Fork
9-2 - Washer
9-1 - M10 locknut