Sanus SSMK1 Anleitung Seite 3

IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE
This product is designed
for use in steel stud walls
Tools required:
Stud Finder
CAUTION:
Thank you for choosing the Sanus
Steel Stud Mounting Kit (SSMK1)
The SSMK1 is designed to be used in conjunction
with the following UL Listed Sanus wall mounts:
Wall Mount Model
VML5
VMT5
VML10
VMT15
ML11
VLL10
VLL5
VLT5
VLT15
LL11
Pencil Level
Maximum Weight
Capacity
34 kg (75 lb)
36 kg (80 lb)
45.4 kg (100 lb)
56.6 kg (125 lb)
68 kg (150 lb)
Screwdriver
CAUTION:
Avoid potential personal injuries and property damage!
●
This product is designed for use in steel stud walls only
●
The wall must be capable of supporting fi ve times the weight of the TV
and mount combined
●
Do not use this product for any purpose not explicitly specifi ed by manufacturer
●
Manufacturer is not responsible for damage or injury caused by incorrect
assembly or use
●
If you do not understand these instructions, or have doubts about the
safety of the installation, assembly or use of this product, contact manu-
facturer Customer Service or call a qualifi ed contractor
●
Studs must be at least 2x4 / 25 ga.
●
If back side of wall is unfinished, drywall must be installed to a minimum of
one stud left and right of the stud(s) being used to install the mount
●
Drywall must be a minimum of 13 mm (1/2 in.) thick on each side of the studs,
and a minimum clearance of 48 mm (1 7/8 in.) behind the wall is required
●
Pilot holes MUST be drilled to a depth of 25 mm (1 in.), using a 13 mm
(1/2 in.) diameter drill bit
●
This product must be centered on the studs
●
Stud type and structural strength must conform to the North American
Specification for the Design of Cold-Formed Steel Structural Members
[362 S 125 18, C-Shape, S - Stud Section]
●
Drywall must be secured to studs with screws 304.8 mm (12 in.) on center
1/2 in.
(13 mm)
Drill Bit Electric Drill
3