Pkm MW 800-20GH Bedienungsanleitung Seite 40

openings to prevent damage to the operating parts inside the appliance.
3. Wipe both sides of the door and the window, the door seals and adjacent parts
frequently using a damp cloth to remove any spills or spatters. Do not use
abrasive cleaners.
4. The control panel should not become wet. Clean it with a soft and damp cloth.
When cleaning the control panel, leave the door open so the appliance cannot
be switched on randomly.
5. If steam accumulates inside or around the outside of the door, wipe it with a
soft cloth. This may occur when the appliance runs under high humidity
conditions; it is a normal occurrence.
6. It is sometimes necessary to remove the glass tray for cleaning.. Wash the tray in
warm soapy water or in a dishwasher.
7. Clean the roller ring and floor of the appliance inside regularly to avoid
excessive noise. Simply wipe the bottom surface with a mild detergent. You may
wash the roller ring in mild soapy water or in a dishwasher. When having
removed the roller ring from the appliance, you must replace it in its proper
position.
8. Remove odours from your appliance by combining a cup of water with the juice
and the skin of one lemon in a deep microwave-suitable bowl. Microwave it for
5 minutes. Wipe thoroughly and dry with a soft cloth.
9. WARNING! If it is necessary to remove the internal light of the
appliance, please contact the shop you purchased the appliance at.
DANGER!
WARNING! MICROWAVE RADIATION！
WARNING! It is hazardous for anyone, other than a qualified service
technician, to carry out any service for repairing operation which involves removal
of any cover which gives protection against exposure to microwave energy.
WARNING! The high voltage capacitor remains charge after disconnection;
short the negative terminal of H. V capacitor to the oven chassis (use a
screwdriver) to discharge before touching.
WARNING! During servicing below listed parts are liable to be removed and
give access to potentials above250V to earth.
1. Magnetron
2. High voltage transformer
3. High voltage capacitor
4. High voltage diode
5. High voltage fuse
WARNING! The following conditions may cause undue microwave exposure
during servicing.
The power cord must be replaced
by a qualified and authorized professional only.
SERVICING SAFEGUARDS
40