Anhang A - Befehlssatz - PeakTech 1885 Bedienungsanleitung

Anhang
BEFEHLSSATZ
Anmerkungen zur Verwendung des Fernprogrammiermodus
Die USB/485-Schnittstelle ist immer für den Anschluss an einen PC zur Fernprogrammierung bereit.
Befehlssatz
{ }-Befehlsdaten, [ ] – zurückgegebene Daten, [OK] = "OK", [CR] = 0 dh
???? = 30h, 30h, 30h, 30h - 39h, 39h, 39h, 39h (4 bytes data)
??? = 30h, 30h, 30h - 39h, 39h, 39h (3 bytes data)
?? = 30h, 30h – 39h, 39h (2 bytes data)
Fett – Eingabebefehl
Kursiv – vom Netzteil zurückgegebene Daten
Input Command:
SESS <address> <CR>
Return Data from Power Supply:
[OK] [CR]
Input Command:
ENDS <address> <CR>
Return Data from Power Supply:
[OK] [CR]
Input Command:
CCOM <address> <RS> {000-256} <CR>
Return Data from Power Supply:
[OK] [CR]
Input Command:
GCOM <address> <CR>
Return Data from Power Supply:
[RS] RS485 Address [??] [CR]
[OK] [CR]
Input Command:
GMAX <address> <CR>
Return Data from Power Supply:
Voltage [???] Current [???] [CR]
[OK] [CR]
Input Command:
GOVP <address> <CR>
Return Data from Power Supply:
Voltage [???] [CR]
[OK] [CR]
Input Command:
GETD <address> <CR>
Return Data from Power Supply:
Command Code & Return Data
13
Description
Disable front panel
keypad and make PS to
Remote Mode
Enable front panel
keypad and make PS to
exit Remote Mode
Change RS485
<RS> = 0 -> RS-232
<RS> = 1 -> RS-485
Get the RS-485
address
Get maximum voltage
and current of PS
Get Upper Voltage
Limit of PS
Get Voltage & Current
reading from PS