Herunterladen Diese Seite drucken

Specifications - Peavey MAX 160 Bedienungsanleitung

Professional bass verstärker

Werbung

N N O O T T E E : : All specifications measure with mains voltage maintained at
nominal level.
M M a a i i n n s s V V o o l l t t a a g g e e = 120 VAC 60 Hz (Fuse: 5 amps)
230 VAC 50/60 Hz (Fuse: 3.5 amps)
100 VAC 50/60 Hz (Fuse: 6 amps)
P P o o w w e e r r C C o o n n s s u u m m p p t t i i o o n n = 200 watts
S S Y Y S S T T E E M M N N O O I I S S E E : :
Typically greater than -85 dB
P P O O W W E E R R A A M M P P L L I I F F I I E E R R S S E E C C T T I I O O N N : :
P P r r o o t t e e c c t t i i o o n n : :
Current limit protection circuit.
Thermal protection circuit.
DDT
speaker protection circuit with defeat switch.
G G E E N N E E R R A A L L I I N N F F O O R R M M A A T T I I O O N N : :
Minimum load = 4 Ohms
DDT
dynamic range: +12 dB
Input sensitivity: 1 V RMS
Two 1/4" output jacks in parallel.
P P O O W W E E R R O O U U T T P P U U T T : :
160 watts (25.3 V RMS) into 4 ohms with no more than 0.1%
THD+N
175 watts (26.46 V RMS) into 4 ohms @ 1% THD+N
110 watts (29.66 V RMS) into 8 ohms with no more than 0.1%
THD+N
120 watts (30.98 V RMS) into 8 ohms @ 1% THD+N
N N O O I I S S E E : :
Greater than 100 dB below full power @ 8 ohms typically
-105 dB
MAX 160

Specifications

P P R R E E A A M M P P L L I I F F I I E E R R S S E E C C T T I I O O N N : :
S S E E T T T T I I N N G G S S F F O O R R F F O O L L L L O O W W I I N N G G M M E E A A S S U U R R E E M M E E N N T T S S U U N N L L E E S S S S O O T T H H E E R R - -
W W I I S S E E N N O O T T E E D D : :
P P r r e e - - G G a a i i n n = 5 (12 o'clock)
C C o o n n t t o o u u r r = 0 (fully CCW)
L L o o w w = 0 (12 o'clock)
M M i i d d = 0 (12 o'clock)
M M i i d d S S h h i i f f t t = 12 o'clock
H H i i g g h h = 0 (12 o'clock)
M M a a s s t t e e r r V V o o l l u u m m e e = 5 (12 o'clock)
H H i i g g h h B B o o o o s s t t = out
P P a a d d = out
D D D D T T
™ ™
= Active
I I N N P P U U T T S S E E N N S S I I T T I I V V I I T T Y Y ( ( L L e e v v e e l l t t o o a a c c h h i i e e v v e e f f u u l l l l p p o o w w e e r r ) ) : :
W W i i t t h h P P a a d d O O u u t t . . . . . .
N N o o m m i i n n a a l l i i n n p p u u t t : : 65 mv
M M i i n n i i m m u u m m i i n n p p u u t t : : 3 mv (pre gain and master fully CW)
M M a a x x i i m m u u m m i i n n p p u u t t : : 2.3 volts (maximum signal at input before
clipping occurs)
W W i i t t h h P P a a d d ( ( - - 1 1 0 0 d d B B ) ) I I n n . . . . . .
N N o o m m i i n n a a l l i i n n p p u u t t : : 205 mv
M M i i n n i i m m u u m m i i n n p p u u t t : : 9.5 mv (pre gain and master fully CW)
M M a a x x i i m m u u m m i i n n p p u u t t : : 7.2 Volts (maximum signal at input before
clipping occurs)
E E Q Q U U A A L L I I Z Z A A T T I I O O N N : :
C C o o n n t t o o u u r r : : special EQ curve
L L o o w w : : ±15 dB (shelving type)
M M i i d d r r a a n n g g e e : : ±15 dB (peaking type)
M M i i d d S S h h i i f f t t : : 200-2 kHz
H H i i g g h h : : ± 15 dB (shelving type)
H H i i g g h h B B o o o o s s t t : : + 10 dB @ 8 kHz
E E F F F F E E C C T T S S L L O O O O P P : :
Set for -10 dB with pre @ 5, Master @ 10
T T U U N N E E R R S S E E N N D D : :
Buffered off input jack with no equalization.
X X L L R R O O U U T T P P U U T T ( ( r r e e f f e e r r e e n n c c e e d d t t o o 1 1 V V R R M M S S = = 0 0 d d B B v v ) ) : :
P P r r e e - - E E q q s s e e l l e e c c t t e e d d : : -2 dBv
P P o o s s t t - - E E q q s s e e l l e e c c t t e e d d : : -3 dBv
8

Werbung

loading