Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb - AEG s 70170 tk38 Gebrauchsanleitung

GB
At this type of appliance defrosting cooling compartment
is automatic without any external intervention.
The thermostatic control interrupts the operation of
compressor at regular intervals for more or less time -
during this cooling is interrupted - temperature of the
cooling compartment increases and defrosting occurs.
After defrosting the thermostatic control restarts
operation of the system.
Melting water flows through defrost water outlet into the
evaporative tray maintained on the top of compressor and
evaporates due to warmth of it.
Check and clean the outlet of melting water
coming during defrosting regularly. If it is
clogged the melting water gathered can cause earlier
failure as it can go to the insulating of the appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe scraper has
to be stored in the outlet.
Occasionally check the defrost water outlet not to be
clogged up.
The most typical case of clogging up in the defrost water
outlet when you put food wrapped in some paper into the
appliance and this paper contacts back plate of cooling
compartment and freezes to it. If you remove the food
right at this moment the paper will tear and it can cause
clogging up in the outlet by getting into it. So you are
asked to be careful - because of the above - when placing
foods wrapped in paper into the appliance.
In case of increased demand e.g. during
heatwaves, the refrigerator temporarily happens
to operate constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on back plate of the
cooling compartment after defrosting period is not
abnormal.
46

Regular cleaning

It is recommended to wash the inside of the refrigerator in
3-4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance using
lukewarm water and wipe it.
Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
Dust and dirt collected on the back of the refrigerator,
condenser is recommended to be removed and clean the
evaporative tray on top of the compressor once or twice a
year.

When the refrigerator is not in use

In case the appliance will not be used for a long time
follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take
the lamp cover off in the direction of arrow and the bulb
can be changed. (Type of the bulb: Mignon 322, 230 V, 15
W, E 14 thread)
After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the
refrigerator.