Technical Data; Closing The Door - AEG A61600GSW0 Benutzerhandbuch

34

Technical data

Problem
There is too much frost.
Upper or lower square is
shown in the temperature
Display.
dEMo appears on the Dis-
play.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
Many products are stored at the
same time.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
An error has occurred in meas-
uring the temperature.
The appliance is in demonstra-
tion mode (dEMo).
Height
Width
Depth
Solution
Store less products at the same
time.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OKbutton since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
1400 mm
600 mm
630 mm
31 h
230-240 V
50 Hz