Safety Measures - Vitek VT-2324 BK Betriebsanweisung

VT-2324_70 x130.indd 3
ELECTRIC HAIR STRAIGHTENER VT-2324 BK
The unit is intended for hair straightening.
DESCRIPTION
1. Heating plates
2. ON indication
3. Power switch «1/0»
4. Handle
5. Hair straightening plates lock
6. Hanging loop
ATTENTION!
Do not use this unit near containers filled with water (such
as a sink, bath etc.).
• When using the unit in a bathroom, unplug it right after
usage by taking the power plug out of the mains socket,
as closeness of water is dangerous even if the unit is
switched off.
• For additional protection you can install a residual cur-
rent device (RCD) with nominal operation current not
exceeding 30 mA into the bathroom mains; contact a
specialist for installation.
• Place the hair straightener on a flat steady heat-
resistant surface or hang it by the loop (6). Make
sure that the heating plates and outer operating
surfaces do not touch fusible and inflammable
objects (plastic, polyethylene, synthetic materi-
als etc.).

SAFETY MEASURES

Before using the unit, read this instruction manual carefully.
Keep this manual for future reference.
Use the unit for intended purposes only, as specified in
this manual. Mishandling the unit can lead to its break-
age and cause harm to the user or damage to his/her
property.
• Before switching the unit on, make sure that the voltage
of the mains corresponds to the unit operating voltage.
• Never leave the operating unit unattended.
• Do not switch the unit on in places where aerosols are
sprayed or highly inflammable liquids are used.
• Hair spray should be applied only after hair straighten-
ing is finished.
ENGLISH
3
19.02.2016 17:26:33