Vitek VT-2324 BK Betriebsanweisung Seite 6

VT-2324_70 x130.indd 6
ENGLISH
• Use the unit only for healthy, non-colored and non-
curled hair or with the usage of special straightening
means.
• If hair is colored or chemically curled, then you can use
the unit only sometimes.
• To get better results of hair straightening, hair should
be clean and dry.
• Put the unit on a flat, stable heat-resistant surface.
• Insert the plug into the socket, set the power switch (3)
to the «1» position, the power indicator (2) will light up.
Note: while first usage of the unit smell from the
heating element can appear, it is allowable.
• Place the hair straightener on a flat steady heat-resis-
tant surface.
• Let the unit heat up for 1-2 minutes.
• Divide untangling hair into locks of equal width (about
5 cm).
• Put a lock between the plates (1).
• Press the plates together, run them till the end of the hair
without strength.
Important: Do not hold the plates for more than
2 seconds on one lock.
• Then straighten the next lock.
• Do not use the unit for more than 30 minutes.
• Cool hair before final styling.
• Avoid contact of heated surfaces with your face, neck
and other parts of your body.
• After you finish using the unit, set the switch (3) to the
«0» position, the power indicator (2) will go out and after
that you can unplug the unit. Let the unit cool down.
Note: Always switch off and unplug the unit if it
is not being used. Never leave the operating unit
unattended.
CLEAN AND CARE
• Before cleaning, unplug the unit and let it cool down
completely.
• Do not immerse the unit into water or other liquids.
• Press the plates (1) together and move the lock (5)
towards the handle (4) to fix them.
• Wipe the body with a damp cloth and then dry it.
• Do not use steam devices for cleaning.
• Do not use abrasives and solvents for cleaning the unit.
6
19.02.2016 17:26:33