Ezlink; Emv; Zulassungen, Zertifikate Und Sicherheit - ABB AWT420 Inbetriebnahmeanleitung

AW T4 2 0 | U N I V E R S A L 4 - L E I T E R E I N - U N D Z W E I K A N A L- M E S S U M F O R M E R | C I/A W T4 2 0 - D E R E V. B

EZLink

Leitungsaufnahme (max.)
150 mA bei 24 V DC (3,75 W max.)
Feste Kabellänge
1 oder 10 m
IP-Schutzart digitaler Steckverbinder
IP67 (im angeschlossenen Zustand)
Verlängerungskabel (Optionen)
1, 5, 10, 15, 25, 50 m
Maximale Länge (einschließlich optionalem
Verlängerungskabel)
maximal 210 m

EMV

Emissionen und Störfestigkeit
Erfüllt die Anforderungen von IEC 61326 für industrielle
Umgebungen

Zulassungen, Zertifikate und Sicherheit

Sicherheitszulassungen
cULus
CE-Zeichen
Erfüllt EMV- und LV-Richtlinien
(einschließlich IEC 61010, neueste Fassung)
Allgemeine Sicherheit
• IEC 61010-1
• Verschmutzungsgrad: 2
• Isolierungskategorie 1
Bluetooth
Das Bluetooth Low Energy Module im Messumformer
AWT420 hat die regulatorische Zulassung für die folgenden
Länder erhalten:
• Europe/CE
Europe
0197
• Japan/MIC: 005-101150
Japan
Contains transmitter module with certificate number:
005-101150
• Korea/KCC: MSIP-CRM-mcp-BM71BLES1FC2
Korea
MSIP-CRM-mcp-BM71BLES1FC2
• China/SRRC: CMIIT ID: 2016DJ5890
China
CMIIT ID: 2016DJ5890
• USA/FCC ID: A8TBM71S2
U.S.
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
recieved, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
35