Hilti PD-S Handbuch Seite 16

Battery (2 x)
Battery life (number of measurements), up to
Laser deactivation after
Device shutdown after
5 Operation
5.1 Preparations at the workplace
5.1.1 Inserting the batteries
Make sure that battery polarity is correct. Change the batteries only as a pair. Do not use damaged
batteries.
▶ Open the battery compartment and insert the batteries.
5.1.2 Switching the product on and off
1. Short-press the ON / Delete / OFF button to switch the product on.
2. Press the ON / Delete / OFF button for 2 seconds to switch the product off.
5.1.3 Switching the acoustic signal on and off
▶ Simultaneously press the Area measurement / Units button and the ON / Delete / OFF button for 2
seconds to switch the acoustic signal on or off.
5.2 Working / Measurement reference
All measurements use the rear edge of the laser range meter as the reference point.
▶ Hold the rear edge of the laser range meter against the point from which the measurement is to be taken.
5.2.1 Taking single measurements
1. Press the ON / Delete / OFF button to activate the laser beam.
2. Aim the laser beam at the target and press the Measure / Continuous measurement button.
➥ The distance is shown in the display.
Press the ON / Delete / OFF button once to delete the last measured values.
Press the ON / Delete / OFF button again to return from area measurement to distance measure-
ment.
5.2.2 Switching the continuous measuring mode on and off
1. Press the Measure / Continuous measurement button for 2 seconds to activate continuous measure-
ment.
➥ The distance is shown in the display.
2. Press the Measure / Continuous measurement button again to end the continuous measurement.
5.2.3 Measuring area
1. Switch on the product. → page 10
2. Short-press the Area measurement / Units button.
3. Measure the length of the area by pressing the Measure / Continuous measurement button.
4. Measure the width of the area by pressing the Measure / Continuous measurement button.
➥ The area is calculated and the result is shown on the display.
5.2.4 Changing units 8
▶ Press the Area measurement / Units button for 2 seconds to toggle from one unit of measurement to
the other.
10 English
2
3
6
4
7
5
2190182
PD-S
AAA
10000
90 s
180 s
*2190182*