Closing The Door; Installation - AEG A51100TSW0 Benutzerhandbuch

Problem
It is too cold inside
the freezer
The appliance does
not work at all. Nei-
ther cooling nor
lighting works
The appliance does
not cool at all

8.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

9. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
Large quantities of food
to be frozen were put in
at the same time
Food placed in the appli-
ance was too warm
Products to be frozen are
placed too closely to
each other
Temperature regulator
may be set incorrectly
Plug is not connected to
the mains socket properly
Power does not reach the
appliance
The appliance is not
switched on
There is no voltage in the
mains socket (try to con-
nect another appliance
into it)
Plug is not connected to
the mains socket properly
There is no voltage in the
mains socket (try to con-
nect another appliance
into it)
The appliance is not
switched on
3.
9.1 Positioning
This appliance should be installed in a
dry, well ventilated indoor where the am-
bient temperature corresponds to the
Solution
Insert smaller quantities of
food to be frozen at any
one time.
Allow food to cool to room
temperature before stor-
ing.
Place the products in a way
so that cold air could circu-
late among them
Set a warmer temperature
Connect the mains plug
properly
Try connecting another
electrical device to the
power outlet
Switch on the appliance
Call an electrician
Connect the mains plug
properly
Call an electrician
Switch on the appliance
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
27