About This Installation; Getting Help - AtriCure CRYO1 Installationsanweisungen

Cryo1 Accessory Kit Installation Instruction

1. About This Installation

The Cryo1 Accessory Kit consists of three (3) unit installation. The installation
of each unit is required for use of the AtriCure
with the frigitronics
kit must be installed by personnel properly trained on the CCS-200.
The three units can be installed in any order:
1. CPR1 – Cylinder Pressure Regulator Unit
2. CPT1 – Cylinder Pressure Temperature Display Unit
3. OTS1/OTS2 – Nitrous Oxide Tank Heater
WARNINGS
The Cryo1 accessory kit is for use with the frigitronics CCS–200 Cardiac
Cryosurgical System and Cryo1–cryo ablation probe.
The Cryo1 accessory kit is used to maintain appropriate operating pressure
levels in the compressed nitrous oxide gas cylinders of the frigitronics CCS–
200 Console.
Do not use with gas cylinders other than nitrous oxide.
CAUTIONS
Read all instructions carefully for the Cryo1 accessory kit prior to installing
the components. Failure to properly follow instructions may lead to injury and
may result in improper functioning of the accessory components.
Use of the Cryo1 accessory kit should be limited to properly trained and qualified
medical personnel.
To avoid damage to the device, do not drop or toss any of the Cryo1 accessory
components.
Do not use the Cryo1 components if damaged in any way.
Do not remove or install Cryo1 accessory components unless the line and
exhaust pressure gauge read "0" psi on the CCS-200 console.
Do not restrict, kink, bend, clamp or otherwise damage nitrous oxide lines.

Getting Help

If you need help with this procedure please contact AtriCure, Inc. Customer
Support at 1-877-492-1066.
®
CCS-200 Cardiac Cryosurgical System (CCS–200). This
3 of 70
®
Cryo1 cryo–ablation probe